meta.frame.xl parts pack i have created to increase frame stability even more. Since on all axis we depend here on aluminium extrusion and wood these horizontal beams are essential for top prints…
This set include adapters to connect another horizontal beam on all three sides adding toughness, top bit enforcers tighten this even more. You will need three of these to place on each axis.
Next we need three of these to join small 10-15 cm aluminium outbound cut. These aluminium bits serve adding more space and rigid connection.
Next bits join on ends off previously mentioned alu spacers. There is total 12 bits, Three of each.
Three of these complete previous set of three and join alu extrusion all around machine.
Three of these and same procedure as with previous two bit sets.
Three of these complete previous set of three and join alu extrusion all around machine.
Finally three of these go on top of each axis and fix connect to upper base segment.
I advise as much infill as you can since these are all designed small and need all the toughness they have. These were printed using nozzles 0.3 to 0.5 mm diameter with great success.
